What are the precautions in transformer operation

All kinds of applications of transformer are ubiquitous, and its application field is relatively wide, and its application is not limited by any time. In many cases, the use and operation of transformers need to pay constant attention to various problems, because transformers are related to the safety performance of power consumption, and must be used properly. When operating the transformer, it is necessary to grasp the safety performance and technical performance. All kinds of operation of transformer must be carried out in a standardized and correct manner, and when there is a fault, learn to solve it. The following are the common basic operation steps and methods of transformers:

1. The transformer must be well grounded to ensure safety;

2. Do not use the handwheel when moving the transformer, but use the handle or lift the whole product to move;

3. Rotate the hand wheel slowly and evenly during use to avoid damage to the brush or spark;

4. From the power supply to the transformer, the wire and wire terminal of the transformer to the load shall be in good contact and can pass the rated current of the transformer;

5. When the transformer needs to be installed horizontally on the large panel or vertically on other bases, the installation hole of the transformer base can be used to fix it;

6. The contact surface between the coil and the brush should be kept clean frequently, otherwise it is easy to increase the spark and burn the coil surface;

7. The transformer is not allowed to have water droplets, oil stains, etc. fall into the transformer, and the power must be cut off regularly to remove the dust accumulated inside;

8. The use of the transformer should be checked frequently. If the brush is found to be too worn or damaged, the brush of the same specification should be replaced in time, and the hand wheel should be rotated several times under the brush with No. 0 sandpaper to make the bottom surface of the brush smooth and in good contact before use.

The above are the basic methods and steps that should be grasped when the transformer is operated for your reference. For the transformer, it is necessary to enhance the understanding of various safety of the transformer, and the basic operation of the transformer should be standardized and carried out step by step! These are all things you should master.